Cisco Configuration Professional - Versionsgeschichte

Thomas am 26. Januar 2016 um 10:22 Uhr

2016-01-26T10:22:08Z

Thomas am 26. Januar 2016 um 10:21 Uhr

2016-01-26T10:21:13Z

Thomas: Die Seite wurde neu angelegt: „=Connect to your router using Telnet, SSH, or through the console.= Enter global configuration mode using this command: Router(config)#enable …“

2016-01-26T10:20:04Z

Die Seite wurde neu angelegt: „=Connect to your router using Telnet, SSH, or through the console.= Enter global configuration mode using this command: Router(config)#enable …“

Neue Seite

=Connect to your router using Telnet, SSH, or through the console.=
Enter global configuration mode using this command:

Router(config)#enable
Router(config)#

=If HTTP and HTTPS are enabled and configured to use nonstandard port numbers, you can skip this step and simply use the port number already configured.=
Enable the router HTTP or HTTPS server using these Cisco IOS Software commands:
Router(config)# ip http server
Router(config)# ip http secure-server
Router(config)# ip http authentication local

=Create a user with privilege level 15:=
Router(config)# username <username> privilege 15 password 0 <password>

Note: Replace <username> and <password> with the username and password that you want to configure. Do not use the same password for your user and enable passwords.

Configure SSH and Telnet for local login and privilege level 15.

Router(config)# line vty 0 4
Router(config-line)# privilege level 15
Router(config-line)# login local
Router(config-line)# transport input telnet
Router(config-line)# transport input telnet ssh
Router(config-line)# exit

(Optional) Enable local logging to support the log monitoring function:

Router(config)# logging buffered 51200 warning

@@ Zeile 5: / Zeile 5: @@
          Router(config)#
-=If HTTP and HTTPS are enabled and configured to use nonstandard port numbers, you can skip this step and simply use the port number already configured.=
+If HTTP and HTTPS are enabled and configured to use nonstandard port numbers, you can skip this step and simply use the port number already configured.
-Enable the router HTTP or HTTPS server using these Cisco IOS Software commands:
+=Enable the router HTTP or HTTPS server using these Cisco IOS Software commands:=
          Router(config)# ip http server
          Router(config)# ip http secure-server

@@ Zeile 13: / Zeile 13: @@
 =Create a user with privilege level 15:=
          Router(config)# username <username> privilege 15 password 0 <password>
 Note: Replace <username> and <password> with the username and password that you want to configure. Do not use the same password for your user and enable passwords.
-    Note: Replace <username> and <password> with the username and password that you want to configure. Do not use the same password for your user and enable passwords.
+=Configure SSH and Telnet for local login and privilege level 15.=
          Router(config)# line vty 0 4
          Router(config-line)# privilege level 15
-         Router(config-line)# login local
+         Router(config-line)# login local   # FUNKTIONIERT BEIM 2651XM NICHT
          Router(config-line)# transport input telnet
          Router(config-line)# transport input telnet ssh
          Router(config-line)# exit
+=(Optional) Enable local logging to support the log monitoring function:=
          Router(config)# logging buffered 51200 warning