PFSense 2) Set interface(s) IP address: Unterschied zwischen den Versionen
Zur Navigation springen
Zur Suche springen
(Die Seite wurde neu angelegt: „ <pre> Available interfaces: 1 - WAN (vtnet0 - dhcp, dhcp6) 2 - LAN (vtnet1 - static) 3 - OPT1 (vtnet2) </pre> *Enter the number of the interface you wish to…“) |
(kein Unterschied)
|
Aktuelle Version vom 13. Februar 2022, 09:21 Uhr
Available interfaces: 1 - WAN (vtnet0 - dhcp, dhcp6) 2 - LAN (vtnet1 - static) 3 - OPT1 (vtnet2)
- Enter the number of the interface you wish to configure: 1
- Configure IPv4 address WAN interface via DHCP? (y/n) n
- Enter the new WAN IPv4 address. Press <ENTER> for none:
> 194.59.156.201
Subnet masks are entered as bit counts (as in CIDR notation) in pfSense.
e.g. 255.255.255.0 = 24
255.255.0.0 = 16
255.0.0.0 = 8
- Enter the new WAN IPv4 subnet bit count (1 to 31):
> 27
- For a WAN, enter the new WAN IPv4 upstream gateway address.
- For a LAN, press <ENTER> for none:
> 194.59.156.193
- Configure IPv6 address WAN interface via DHCP6? (y/n) n
- Enter the new WAN IPv6 address. Press <ENTER> for none:
> Disabling IPv4 DHCPD... Disabling IPv6 DHCPD...
- Do you want to revert to HTTP as the webConfigurator protocol? (y/n) y
Please wait while the changes are saved to WAN... Reloading filter... Reloading routing configuration... DHCPD... Restarting webConfigurator... The IPv4 WAN address has been set to 194.59.156.201/27