Cisco Policy-Based Routing: Unterschied zwischen den Versionen
Zur Navigation springen
Zur Suche springen
Thomas (Diskussion | Beiträge) |
Thomas (Diskussion | Beiträge) |
||
| Zeile 22: | Zeile 22: | ||
**end | **end | ||
*reload | *reload | ||
=Acl mit Source Adressen anlegen | |||
*ip access-list extended sources-to-nagus | |||
**permit ip host 192.168.240.44 any | |||
**end | |||
=Route map erstellenß= | |||
*route-map over-nagus permit 10 | |||
**match ip address sources-to-nagus | |||
**set ip next-hop 172.25.125.3 | |||
**end | |||
=Anwenden auf das Incomming Interface= | |||
*interface Vlan18.0 | |||
**ip policy route-map over-nagus | |||
=Links= | =Links= | ||
Version vom 12. April 2016, 17:58 Uhr
Switching Database Manager muss auf routing stehen
- show sdm prefer
The current template is "desktop routing" template.
The selected template optimizes the resources in
the switch to support this level of features for
8 routed interfaces and 1024 VLANs.
number of unicast mac addresses: 3K
number of IPv4 IGMP groups + multicast routes: 1K
number of IPv4 unicast routes: 11K
number of directly-connected IPv4 hosts: 3K
number of indirect IPv4 routes: 8K
number of IPv4 policy based routing aces: 0.5K
number of IPv4/MAC qos aces: 0.5K
number of IPv4/MAC security aces: 1K
Ändern des SDM und reload
- config terminal
- sdm prefer routing
- end
- reload
=Acl mit Source Adressen anlegen
- ip access-list extended sources-to-nagus
- permit ip host 192.168.240.44 any
- end
Route map erstellenß
- route-map over-nagus permit 10
- match ip address sources-to-nagus
- set ip next-hop 172.25.125.3
- end
Anwenden auf das Incomming Interface
- interface Vlan18.0
- ip policy route-map over-nagus